Need help?Do you have a question about the Aiwa HV-GX910 and is the answer not in the manual?
General| Recording Speed | SP, LP, EP |
|---|---|
| Playback Speed | SP, LP, EP |
| Playback Head | 4-Head |
| Audio Output | Mono |
| Remote Control | Yes |
| Tuner | Yes |
| Timer Recording | Yes |
| Inputs | Composite video/audio |
| Outputs | Composite video/audio |
| Connections | Composite video/audio, RF |
Instructions for removing the top case of the VCR.
Procedure for detaching the front panel.
Steps to remove the main mechanism unit.
Guide for removing the Main Circuit Board.
Details on where to install spacers for service mode.
Audio signal flow during playback.
Audio signal flow during recording.
Video signal flow during playback.
Video signal flow during recording.
Details on the pin functions and descriptions of the HD3977RC17F IC.
List of necessary tools and test equipment for adjustments.
Diagram showing where adjustments are made on the main board.
Procedure for adjusting the Pulse Generator (PG) signal.
Location of mechanism parts viewed from the top.
Location of mechanism parts viewed from the bottom.
Steps for removing and disassembling the drum assembly.
Procedure for removing the top plate assembly.
Steps for removing the Guide CST component.
Procedure for removing the Arm Assembly F/L.
Steps for removing the arm assembly cleaner.
Procedure for removing the Head F/E component.
Steps for removing the A/C head base assembly.
Procedure for removing the Brake Assembly S.
Steps for removing the arm assembly tension.
Procedure for removing the Reel S and Reel T.
Procedure for removing the VCR's opener lid.
Steps for removing the arm assembly for tape take-up.
Procedure for removing the pinch arm assembly.
Steps for removing the belt and motor capstan.
Procedure for removing the Clutch Assembly D33.
Steps for removing gear assemblies H-Up/D or Up/D.
Steps for removing gear drive, cam, and connector.
Procedure for removing the L/D motor bracket assembly.
Steps for removing the gear sector.
Procedure for removing base tension, plate, and lever.
Steps for removing gear assemblies P3 and P2.
Procedure for removing the arm assembly idler.
List of tools and fixtures required for mechanical adjustments.
Details on alignment tapes used for VCR adjustment procedures.
Procedure to check the correct alignment of mechanism parts.
Steps to prepare the mechanism for adjustment without tape.
Procedure to measure and check tape transport torque.
Initial adjustment of guide roller height and tape path.
Fine adjustment of guide roller height for optimal tape path.
Initial height and tilt adjustment of the A/C head.
Check for smooth tape passage over guides and rollers.
Fine adjustment of the A/C head's azimuth for signal quality.
Procedure to adjust X-value for compatibility with other VCR models.
Steps to correct shifts after drum assembly replacement.
Procedures to verify tape movement and function after reassembly.
Verify audio and RF signal lock times during playback.
Inspect for tape curling or jamming issues.
Initial checks and cleaning recommendations before maintenance.
Explanation of why precise components and maintenance are crucial for VCRs.
Guidelines for periodic inspection and maintenance based on usage.
General steps for performing inspection and maintenance.
Instructions and locations for applying grease to mechanism parts.
Troubleshooting guide for common deck mechanism faults.
Troubleshooting guide for issues related to cassette loading.
To Next Page
