To Next PageTo Next Page
Need help?Do you have a question about the Aiwa PX-E855ZZ and is the answer not in the manual?
General| Motor | DC servo motor |
|---|---|
| Speeds | 33 1/3, 45 RPM |
| Signal-to-Noise Ratio | 70 dB |
| Overhang | 15 mm |
| Cartridge Type | Moving Magnet |
| Frequency Response | 20 Hz - 20 kHz |
| Recommended Load Impedance | 47 kΩ |
| Output | RCA |
| Power Supply | AC 120V, 60Hz |
| Output Voltage | 2.5 mV |
| Platter | Aluminum die-cast |
| Type | Belt-drive turntable |
| Tonearm | Static balance straight tonearm |
Do not expose the appliance to rain or moisture to prevent fire or electric shock.
Do not remove the cover or back to prevent electric shock; refer servicing to qualified personnel.
Avoid placing the turntable on slanting, vibratile surfaces, or near electrical appliances.
Check that the rated voltage of your set matches the local voltage before use.
Unplug when not in use; disconnect by plug. Clean stylus back-to-front and cabinet with soft cloth.
Connect the unit to the AIWA MIDI system or another main system, setting the selector correctly.
Connect the red plug to the right-channel jack and the white plug to the left-channel jack.
Instructions for assembling the turntable, including belt, mat, and dust cover.
Steps for playing a record: unlock tonearm, place record, select speed/size, and start play.
The tonearm automatically returns to the arm rest when the record finishes playing.
Instructions on how to lift or stop the stylus during playback.
Steps for manual playback, including moving the tonearm and starting playback.
Guidance on when and how to replace the stylus, and where to obtain replacements.
