AJA io 4k User Manual (English)

Other manuals for AJA io 4k

Installation And Operation Guide76 pages

Questions and Answers:

W
williamsrebeccaAug 1, 2025
What to do if AJA Recording Equipment drops frames during record?
- N
  nortonamyAug 1, 2025
  If you're experiencing dropped frames during recording, it could be due to a few reasons. One potential cause is that the RAID system cannot sustain the data rate required by the capture preset codec. Another reason may be that virus checking software is running in the background; if this is the case, try disabling it. Also, verify that the scratch drive is correctly set to the RAID.
M
Matthew KingAug 6, 2025
Why does my AJA io 4k Recording Equipment drop frames during playback?
- I
  ibarralauraAug 6, 2025
  If your AJA Recording Equipment is dropping frames during playback, it might be due to virus checking software running in the background. If so, disable it. Another possible cause is that the scratch drive is not set to the RAID.
J
Jose BarrAug 11, 2025
How to fix AJA Recording Equipment disk RAID if it cannot keep up?
- E
  ericwalkerAug 11, 2025
  If your disk RAID cannot keep up, resulting in dropped frames, ensure the disk system is providing at least a 50 MB/second sustained transfer rate.
K
Kimberly WolfeAug 16, 2025
What to do if AJA Recording Equipment is not capturing media from desired external device?
- E
  Elizabeth EllisonAug 16, 2025
  If media is not being captured from the desired external device, check the settings in the Input screen of the Io XT Control Panel application. Also, check the equipment cables.
A
Amber KramerAug 21, 2025
Why does AJA Recording Equipment video stutter during playback?
- H
  harold78Aug 21, 2025
  Video stutter during playback can occur if the RAID cannot sustain the data rate.
K
kathryncalhounAug 27, 2025
Why does a red render bar occur when placing a clip on a sequence in AJA io 4k Recording Equipment?
- S
  Scott OsborneAug 27, 2025
  A red render bar appears when placing a clip on a sequence if the sequence setting does not match the clip setting.