20
Let the machine cool completely before changing the cover.
Otherwise it may burn whoever is operating the machine.
Turn the power off before doing this operation.
For optimal performance use a factory original cover made only by Sankosha.
Using another company’s cover may give a bad finishing.
Sankosha takes no responsibility if you do not use factory original covers & padding.
How to replace the covers
1. Lower Body
（1） Put Lower Body Cover on body and attach both side
Velcro tapes which are in the bottom of cover.
（2） There are the covers for front and center vents
clamp base plate and side expander plates inside
of the Lower Body Cover.
Loosen strings of those covers and put the
covers on each plate.
Then tie the strings.
（3） Pull strings which are attached on bottom of Lower Body Cover under the metal fitting and tie
them not to leak blower outside.
Center Vents clamp
base plate
Side expander plate
CAUTION
Velcro tape
Lower body cover
Metal fitting
Metal fitting
String
Lower body cover
Front clamp base plate
Side expander plate
To Next Page
Loading...