Akai 1710W

Take-up
reel
shaft
does
not
rotate
when
recording
tape
is
placed
on
unit.
F
7.
Unit
does
not
rewind
tape.
Supply(rewind) reel shaft does not
rotate even without placing recording
tape on unit.
Supply(rewind)
reel
shaft
does
not
rotate
when
tape
is
placed
on
unit
I—
Troubles with motor.
Troubles with power
T
transmission mechanisn.
Defective
reel
Take-reel
warped
and
sticking
to
deck
top
panel.
Check motor torque.
Replace motor if required.
|
totes
and
replace
C602.
|
a)
Check
guide
roller.
Re-oil
or
replace.
Check and replace reel,
Decreased motor torque.
Defective motor startin
capacitor C602.
Excessive slippage of clutch
material (felt) in take-up reel
shaft assembly.
Check take-up reel sha
assembly.
Tape
guide
roller
does
not
rotate
smoothly.
Troubles with power
transmission mechanisn.
Oil attached to rewind idler
or motor bushing.
| Wipe off oil.
Troubles with motor.
Trouble with power
transmission mechanism.
: s
Detective
reel
Sticking
to
deck
top
panel.
Intermediate idler (black |
Check internal idler.
bakelite wheel} not working
e
Ti
correctly.
ghten
motor
bushing
mounting
screw.
Rewind
idler
does
not
rotate
Check
rewind
idler.
or
not
in
position.
Clean
and
re-Qil.
a
I
Supply
reel
shaft
assembly
does
not
rotate
smoothly.
Decreased motor torque.
Defective
motor
starting
capacitor
C602.
Loose motor bushing.
Check supply reel shaft
assembly:
Clean
and
Re-oil.
Check
motor
torque.
Replace
motor
if
not
repairable.
Replace C602,
Check
supply
reel
shaft
|
assembly.
ot
Check
guide
roller.
Re-oil
or
L
replace,
nd
Check
and
replace
reel.
Excessive
slippage
of
clutch
material(felt)
in
supply
ree}
shaft
assembly.
Tape guide roller does n
rotate.
upply
(rewind)
reel
warped
a
8.
Loose
tape
winding
after
being
placed
in
Rewind
or
Fastforward
mode.
Decreased back tension of take-up and
Supply reel shaft assemblies.
—
9.
Tape
spills
when
stopped
fro
Excessive slippage of felt clutch
Material
in
take-up
and
rewind
reel
shaft assemblies.
Reels of different size are used.
For
example,
5’reel
on
take-up
side
and
?” reel on supply side.
——
Disassemble reel
| Sains
m Rewind or Fast
shaft
assemblies
and
strengthen
back
tension
|
Forward
mode.
Readjust
slippage
of
felt
clutch
material.
Replace
defective
reel
shaft
assembly
if
|
this
readjustment
is
difficult.
Always
use
reels
of
same
size
on
both
sides.
|