Akai 1710W

10. Brake does not function properly.
Worn-out brake shoes. Check and replace brake shoes.
Oil attached to surface of brake shoes. Wipe off oil with cotton swab soaked in alcohol.
Loose brake shoes. Tighten brake shoes mounting screw.
Brake lever does not function properly. Check and re-adjust brake lever.
11. Periodical clack noise when rewinding or fast forwarding tape.
Worm-out and rugged idler wheel. Check idler wheel.
12. Loud motor vibration.
Loose motor mounting screw. Tighten mounting screw.
Defective motor starting capacitor C602. Replece C602.
Loose oil cover mounting screw. Tighten mounting screw.
13. Squeaking noise when playing tape.
Dirty head surface. Clean heads.
Recording
tape
is
being
charged
with
5
static
electricity.
Beplere
recoang
HPs
Excessive heat on head surface after
continued operation. Check tape head.
Old and worn-out recording tape. Inspect recording tape.
|
Inferior
recording
tape.
Use
recording
tape
of
good
quality.
14: Automatic stopping device does not function.
Automatic
stop
lever
moves
normally.
Micro
switch
(S603)
does
not
work
properly.
Check
S603.
Automatic stop lever does not move or
sticky.
Broken lever spring or lever spring not in position.
Ey
Check lever spring.
Automatic
stop
lever
sticks
to
rear
deck
panel.
}—-}
Check
rear
side
of
deck
sub-plate.
15. Cycle change switch does not move.
No
lubricant
on
cycle
conversion
lever.
Relubricate
lever
Eccentric
or
bent
cycle
conversion
lever.
Check
cycle
conversion
lever.
Capstan drive belt not on driving track of flywheel. Check capstan drive belt.
Loose motor bushing. Tighten mounting screw.
Loose
motor
mount
screw.
Tighten
mounting
screw.
Oil
on
motor
bushing
or
on
flywheel.
Wipe
off
oil
with
cotton
swab
soaked
in
alcohol.
|