Akai ABTS-50

EN - ENGLISH
1.Turn the power button to “ON”, The Power button turn blue and twinkle quickly, then enter
Bluetooth mode and make a tone “Bluetooth Device Ready to Pair”.
2.Activate Bluetooth of mobile phone and search for device name “ABTS-50” then connect it.
The power button stops twinkling and make a tone “Bluetooth Device Connected
Successfully” once connected.
3. Play the music from your mobile phone and enjoy.
4. Press Forward or Backward button on the device or on Mobile phones to select songs you
like.
5. Press Play/Pause button on the device or on Mobile phones to play/pause the music.
6. Long press Forward or Backward button to adjust volume up and down. Or adjust the
mobile phones’ volume.
7. Long press Play/Pause button to activate Mobile phone voice control function SIRI /
GOOGLE ASSISTANT;
Playing music from USB disk & Micro SD card:
1. Turn the Power button to “ON”.
2. Insert Micro SD card or USB flash disk into slot, the speaker will make a tone “Music
Play Mode”, and play the stored music automatically.
3. Under playing mode, short press Forward or Backward button to select songs you like,
long press to adjust the volume up and down.
4. Press Play/Pause to play or pause.
Remark: Under Bluetooth playing mode, insert Micro SD or USB will disconnect the
Bluetooth and switch to play the USB or Micro SD card. You can press the MODE button to
switch to Bluetooth mode again.
FM Radio:
1. Under FM radio state, the audio cable provided treat as antenna. Please Insert the
audio cable to get best FM signal before using.
2. Turn the power button to “ON”, press the “MODE” button, the speaker will prompt
“The Radio Mode” when entering FM state.
3. Under playing mode, short press “Play/Pause” button to auto search the FM Channel
and store it automatically.
4. Press Forward or Backward button to change the stored FM channel.
TWS Function:
1. Turn on two identical speakers you want to pair, please noted they must be the same BT
paring name, both under BT mode. Only need to set one of the two units;
2. Press the “TWS” button, speaker will make a tone “di” to start to pair, it will make “di” 3
times and TWS button will keep lighting after paired successfully;
3. Make Bluetooth connection with your mobile phone to play music by the two paired
Speakers to create more powerful surround sound effect.
4. When you want to exit the TWS mode, press “TWS” button (of the unit you set at
beginning) again to exit the TWS function.
AUX-IN: