- 21 -
RADIO OPERATION
1. Press the FUNCTION button to select RADIO.
2. Press the STOP button on the front panel or the BAND button on the remote control to select FM or MW.
3. Press the
TUNING buttons on the remote to tune in to a desired station.
FM Stereo
Press the MONO/STEREO button on the remote control until “ ” appears on the front panel display.
Weak FM stations
Press the MONO/STEREO button on the remote control until “ ” appears on the front panel display.
Background noise will be reduced but the signal reproduced will be mono. To restore stereo reception, press the
MONO/STEREO button on the remote control to select “ ”.
Searching for a Station Automatically
• Press and hold the TUNING buttons on the remote until the tuner starts searching for a station, then
release. After tuning in a station, the search stops.
• The search may not stop at a station with a very weak signal.
Presetting Stations
The unit can store a total of 40 stations in memory (20 FM, 20 MW). Presetting allows you to tune in to a station directly.
1. Press the STOP button on the front panel or the BAND button on the remote control to select FM or MW.
2. Press the TUNING buttons to tune in to a desired station.
3. Press the MEMORY button on the remote control.
4. Press the corresponding number buttons on the remote control for the preset station. The current station is
stored in memory.
Example: To enter the preset number 2, press the “0” & “2” buttons.
To enter the preset number 15, press the “1” & “5” buttons.
5. Repeat steps 1-4 to store other stations.
Tuning in to a Preset Station
1. Press the STOP button on the front panel or the BAND button on the remote control to select FM or MW.
2. Press the PREV / NEXT button repeatedly to select the number of the preset station or use the
numbered buttons to enter the number of the preset station.
To Next Page
Loading...
