EasyManua.ls Logo

Akai AK-DW15P

Akai AK-DW15P
38 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | info@tempo.org
26
Starting a wash program
Open the door and draw out the lower basket. Load your dishes and push the
basket back into place. Then load the upper basket the same way (see pages
16–20 for details).
Add dishwasher detergent according to the instructions (see pages 21-23).
Unless you use dishwasher detergent tablets that contain a rinse aid, make sure
there is sufficient liquid rinse aid in the rinse aid dispenser (see pages 24-25).
Close the dishwasher door, making sure you hear a click when it closes properly.
Insert the plug into a suitable power socket (the power supply is 240V~ 50Hz) and
make sure the water supply is turned on to full pressure.
Press the POWER button on the dishwasher control panel (see page 8).
Press the PROGRAM button, repeatedly, to select the desired wash program from
the following: Intensive - Heavy - Normal - 90 min - Fast 30 - Soak. The selected
program’s indicator light will illuminate (see page 9).
Press the START/PAUSE button to start the washing program (see page 8).
At the end of the program, press the POWER button to switch off the dishwasher.
We recommend you open the door slightly (about 5cm) to assist in drying.
Setting a delayed start
Press the DELAY button, repeatedly, to delay the start time of any program
automatically by up to 24 hours.
Changing a program
If you want to change the wash program, you must do so soon after the start,
otherwise the detergent may have already been released and the wash water drained,
in which case you must refill the detergent dispenser (see pages 22-23).
To change a program soon after the machine has started washing:
Press the START/PAUSE button to pause the incorrect wash program.
Press the PROGRAM button and choose the correct wash program.
Press the START/PAUSE button to continue running the correct program.
NOTE:
* If you open the door to the dishwasher when a washing cycle is underway, the
appliance will pause, emit a warning signal and [ E1 ] will be shown on the display.
* When you close the door, the machine will continue working after 10 seconds.
Instructions (Cont.)

Related product manuals