After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | info@tempo.org
27
Instructions (Cont.)
Forgot to add a dish?
Additional dishes can be added any time before the detergent dispenser opens.
• Press the START/PAUSE button to pause the washing.
• Open the door a little and wait until the spray arm stops working, then open the
door completely.
• Add additional dishes.
• Close the door and press the START/PAUSE button. The dishwasher will continue
with the program after 10 seconds.
WARNING! It is dangerous to open the door mid-cycle as hot water or steam may
escape and scald you. Open the door very carefully.
At the end of the wash program
When the working program has finished, a buzzer will sound six times and then stop.
• Turn off the appliance using the POWER button.
• Open the door — take care when opening the door as hot steam may escape.
• Leave the door ajar and wait at least a few minutes before unloading the
dishwasher to avoid handling the dishes and utensils while they are still hot and
more susceptible to breakage. They will also dry better. We recommend allowing
dishes to cool for around 15 minutes before removing them from the dishwasher.
• When unloading the dishwasher, empty the lower basket first and then the upper one
so water from the upper basket will not drip onto the dishes in the lower basket.
CAUTION! Do not pull out both the upper and lower baskets at the same time,
which may lead to the appliance tipping forward.
• It is normal that the dishwasher is wet inside. You may wipe the inside of the door
with a dry cloth or leave the door slightly ajar for moisture to evaporate.
NOTE: If you are not going to use the dishwasher for a period of time, please shut off
the water supply.
Program indicator lights
The program lights indicate the current state of the dishwasher.
One of the program lights is on. The dishwasher is running.
One of the program lights is blinking. The dishwasher is in pause mode.
All program lights start blinking.
The dishwasher is out of order. Turn off the
power and water supply and contact our after
sales support centre for advice on service.
To Next Page
Loading...