Akai AT-S55/L

“|. SPECIFICATIONS
POWER AMPLIFIER SECTION
RATED POWER OUTPUT 55 watts. per channel, minimum RMS, at 8 ohms from 20Hz
(2-Channel Driven) to 20,000Hz with no more than 0.05% total harmonic distortion.
POWER BANDWIDTH 5Hz to 60kHz/8 ohms
(Total Harmonic Distortion: 0.07%)
SIGNAL TO NOISE RATIO (IHF)
PHONO Better than 85dB
AUX Better than 102dB
RESIDUAL NOISE Less than 180pV at 8 ohms
CHANNEL SEPARATION (IHF) Better than 60dB at 1,000 Hz
DAMPING FACTOR More than 60 (1kHz, 8 ohms)
OUTPUT SPEAKERS | A, B (4 to 16 ohms)/A+B (8 to 16 ohms)
HEADPHONES | _ 4 to 16 ohms
PRE AMPLIFIER SECTION
INPUT SENSITIVITY/IMPEDANCE
PHONO 3mV/47 kohms
AUX 150mV/100 kohms
TUNER 150mV/100 kohms
TAPE MONITOR 150mV/100 kohms
OUTPUT LEVEL/IMPEDANCE
TAPE REC 150mV
PRE OUT 1V/600 ohms
FREQUENCY RESPONSE
PHONO (RIAA Deviation) 20Hz to 20kHz +0.3dB
TUNER, AUX, TAPE 6Hz to 100kHz +0dB, —3dB
TONE CONTROL
BASS +8dB at 100Hz
TREBLE +8dB at 10kHz
LOUDNESS CONTROL +10dB at 100Hz, +6dB at 10kHz
(Volume control set at -30dB position)
LOW CUT FILTER —6dB/oct. at 18Hz.
MISCELLANEOUS
POWER REQUIREMENTS 100V, 50/60Hz for Japan
120V, 60Hz for U.S. A. and Canada
220V, 50Hz for Europe except UK
240V, 5OHz for UK and Australia
110V/220V/240V, 50/60Hz internally switchable for other
countries
POWER CONSUMPTION U/T Model: 200 Watts, JPN Model: 130 Watts
DIMENSIONS JPN Model: 440(W) x 105(H) x 323(D) mm
Other Models: 440(W) x 105(H) x 383(D) mm
(17.3 x 4.1 x 15.1 inches)
WEIGHT JPN Model: 8.6 kg
Other Models: 10.1 kg (22.2 Ibs)
* For improvement purposes, specifications and design are subject to change without notice.
26