Akai CFTD2052

DISASSEMBLY INSTRUCTIONS
B2-1
2. REMOVAL OF DVD DECK PARTS
2-1:
Remove the 3 screws (1).
Remove the Loading Motor Ass'y.
Remove the 2 screws (2).
Remove the Motor and Loading Worm.
Disconnect the following connector: (CP2).
Remove the screw (3).
Unlock the 2 supports (4) and remove the Start SW
PCB Ass'y.
Unlock the 2 supports (5) and remove the End SW
PCB Ass'y.
1.
2.
3.
4.
5.
6.
7.
8.
Fig. 2-1-A
NOTE
1.
2.
In case of the Loading Worm installation, check if the
value of the Fig. 2-1-B is correct.
When installing the wire, install it correctly as Fig. 2-1-B.
Fig. 2-1-B
LOADING MOTOR ASS'Y/START SW PCB ASS'Y/
END SW PCB ASS'Y (Refer to Fig. 2-1-A)
Loading Motor Bracket
(1)
(1)
(1)
Motor
Loading Worm
Start SW PCB Ass'y
(2)
(2)
(3)
(4)
(4)
(5)
(5)
End SW PCB Ass'y
29.7 ± 0.1mm
Safety surface for pressing
of the insert.
Motor
Loading Worm
Fig. 2-1-C
Start SW PCB Ass'y
End SW PCB Ass'y
Motor
Red
Black
Red
Black
2-2:
Remove the screw (1).
Remove the Traverse Unit Rod.
Remove the 2 screws (2).
Unlock the 2 supports (3) and remove the CD Deck
Block.
Remove the 2 screws (4).
Unlock the 2 supports (5) and remove the Traverse
Unit Holder.
Remove the 4 Insulators.
1.
2.
3.
4.
5.
6.
7.
TRAVERSE UNIT ROD/TRAVERSE UNIT HOLDER/
CD DECK/INSULATOR (Refer to Fig. 2-2)
2-3: MOUTH ASS'Y (Refer to Fig. 2-3)
Remove the 2 screws (1).
Remove the Mouth Ass'y.
1.
2.
Fig. 2-3
(1)
Mouth Ass'y
• Screw Torque: 1 ± 0.2kgf•cm
Fig. 2-2
• Screw Torque: 3 ± 0.5kgf•cm
Traverse Unit Rod
(1)
(2)
CD Deck
(2)
(3)
(3)
(4)
(4)
Traverse Unit Holder
Insulator
Insulator
Insulator
Insulator
(5)
(5)
(1)
• Screw Torque: 0.8 ± 0.2kgf•cm