Akai GX-266D

V. MECHANISM
PINCH ROLLER
MICRO SWiTCH SW905
QUICK PLATE
Fig. 1
I. PINCH ROLLER POSITION ADJUSTMENT
AT STOP MODE (Refer to Fig. 1)
1) Remove head block.
2) Adjust Stopper so that the clearance between
Pinch Roller and Capstan Shaft is 10mm.
Fig. 2
2. POSITION ADJUSTMENT OF PINCH ROL-
LER SOLENOID SL-3 (Refer to Fig. 2)
1) Remove head block.
2) Insert a 4.2 mm gauge (a U type washer etc.)
between the P Plunger Lever and P Joint (Refer to
Fig. 3).
3) Set the deck to playback mode and fix Pinch
Roller Solenoid at position at which the pinch
Roller begins to rotate.
3. PINCH ROLLER PRESSURE ADJUSTMENT
(Refer to Fig. 3)
Adjust Pinch Roller Pressure Adjustment Nut so that
pinch roller pressure is 1.2 kg.
4, POSITION ADJUSTMENT OF QUICK PLATE
(Refer to Fig. 1)
Adjust Quick Plate position so that at stop mode,
the Pinch Roller Microswitch operates properly, and
the Quick Plate does not strongly hit against the body
of the microswitch.
ADJUSTMENT
PINCH ROLLER PRESSURE
ADJUSTMENT NUT —
1.3 to 1.4 kg
P PLUNGER LEVER
5. POSITION ADJUSTMENT OF BRAKE
SOLENOID SL-1 (Refer to Fig. 4)
Set the deck to playback mode, and fix Brake
Solenoid at position at which the left and right brake
levers display 180° angle relativity.
6. POSITION ADJUSTMENT OF BRAKE
MICROSWITCH SW-906 (Refer to Fig. 4)
Set the deck to playback mode, and adjust Brake
Solenoid Microswitch position so that the micro-
switch operates properly.
7. BRAKE TENSION ADJUSTMENT (Refer to
Fig. 4)
Adjust Spring Stopper position so that the brake
tension is 350 to 500g.
BRAKE SOLENID SL-1
REEL MOTOR BRAKE MICROSWI'cH
Soe sooe MICROSWITCH Sw908 SwoE
i
PAUSE MICROSWITCH
SW-903, SW-307
PAUSE SUDE 0.3405 mm