Akai ME30P

5
OPERATION
1
.
When
using
for the
first
time, hold the
BANK
switch depressed
and turn on
the
POWER switch at
the same
time. (This
is
to
clear the
memory
banks.)
BANK
OUTPUT
CH
2. Press the
BANK
switch and
set the
desired bank
number.
The
number
indicated
by LED is increased
each time the
switch is
pressed.
After
pressed 10 times,
letters A through
F
will be
displayed.
3.
Assign the
output
by pressing
the
desired
OUTPUT
GH
switch(es)
to set the corresponding output channelis).
/
1
8AMK
OUTPUTCM
s.
1
H
BANK
OUTfUTCH
Press the
INPUT
CHANNEL
switch to select
the input
channel
for
the assigned output.
A red dot
will
be displayed to
verify that this has
been done.
•
The
first group in the patch has
now
been
set.
To
set subsequent
groups,
repeat steps
(3)
and (4)
above.
H
1
WPUTOUMNB.
,
A
BCD
^^^^^^^^^^^
^^^^1^^
m»HiWMfla|
mmmaam
Q
Q
Ilii
5. Press the
BANK
switch
to
set
other bank
numbers,
then
follow steps
(3)
and (4)
above
to
set
other pastPhes,
Performing
Connection
Check
1
.
Pre^s the
MMK
switchl
2.
Press the
CHECK
switch.
(The indicator will light.)
^
BANK
OUWrCH
1
SANK
OUDVrCH
m
3. When
the
INPUT CHANNEL
switch is pressed, the
M\0\
pitch
number 69
signal Is
transmitted
to
all
equipment
connected
to
that input.
4. The check
mode is cancelled by
pressing the
CHECK
switch
once again.
After doing this,
make sure the
indicator
has
turned
off.
occx
-WKHJTCHAMW.-
B C
NOTE: Be sure to
press
the
CHECK
switch
to cancel the
check
mode. If an
OUTPUT
CH
switch is
pressed
while
the
CHECK
Indicator
is
lit,
the input
signals of the
connected
equipment
will
not
be
received
and
normal
operation
will
ttecome
impossible.