1
1
ACV0 Performance Testing Instructions
Shane Hazleton 6/18/2012 Ver 8
Overview
The ACV0 performance test is done with the ACV0 Tester application which checks the
quality of Midi I/O, audio quality, and can be used to serialize a unit.
Required Hardware/Software
ACV0 with latest FW
MPC5000 or IO26
ACV0 USB Audio Driver installed –
A PC
A USB A to B cable
2 MIDI Cables
Foot pedal
Any combination of audio cables that allow you to connect:
2 RCA to 2 ¼ inch unbalanced phone plug (left right)
2 RCA to RCA Cables
2 ¼ inch balanced phone plug (left right) to XLR Cables
1 ¼ inch Stereo to split mono ¼ inch plug (for headphones)
1/8 inch Stereo to split mono ¼ inch plug (for headphones)
Procedure
First install the drivers.
Open the ACV0 Performance Tester application.
Configure 1 time settings which should automatically be recognized anyway.
Although not necessary the first time, on the assembly line the user will set up the audio
cables as outlined in the audio test section before beginning the test. This is done to
maximize efficiency while the app refreshes after plugging in the USB cable from a new
unit.
To Next Page
Loading...
Need help?
General
