SPIDIF
Using MPC5000
Output will be routed from the S/PDIF out to the MPC5000 and then Back to the S/PDIF.
MPC5000 setup:
-In INPUT THRU page, set Input Thru = ON and set Src = DIGITAL
-Go to REC SAMPLE mode
-In REC SAMPLE page, set Input = DIGITAL
Using IO/26
Load included SPDIF Loopback.hdm to the Alesis iO Hardware Direct Monitoring
control panel and loop through the IO26 S/PDIF
Serialization
To serialize the ACV0, we are using a USB Barcode scanner that outputs ASCII (text)
when a barcode is scanned. Any scanner that does this should work but the one we tested
with is a Unitech MS210-1BG .
Before the tester is allowed to scan the serial into the unit, the unit must have passed all
tests.
Because of the nature of the scanner, the tester may need to scan the barcode twice or
more to get the unit serialized. When a successful serialization has taken place, the serial
number in the unit is displayed and “Serialized” is shown.
The test is complete.
Thank You!
To Next Page
Loading...
Need help?
General
