12
Switches: Press the switches to select modes or enable/disable certain track parameters,
depending on MPD232’s current control bank:
• Control Bank A: Press a switch to select the mode for the pads:
o Switch 1: Press Switch 1 to select Instrument Mode (described above).
o Switch 2: Press Switch 2 to select Clip Mode (described above). Once you are in
this mode, you can press Switch 2 to switch between Tracks 1–4 and Tracks 5–8.
o Switch 3: Press Switch 3 to select Scene Mode (described above).
o Switch 4: Press Switch 4 to turn notifications on or off. When on, a small message
will appear when you adjust a control, enter another mode, etc.
o Switch 5: Press Switch 5 to shift the “clip window” up by one scene. (The clip
window is the 4x4 area of clips you can launch with the pads in Clip Mode.)
o Switch 6: Press Switch 6 to shift the “clip window” down by one scene. (The clip
window is the 4x4 area of clips you can launch with the pads in Clip Mode.)
o Switch 7: Press Switch 7 to instrument mode select the previous device in the
active track’s device chain. Clip/scene select prev track
o Switch 8: Press Switch 8 to instrument mode select the next device in the active
track’s device chain. Clip/scene select prev track
• Control Bank B: Press the switches to record-arm or -disarm the tracks. Each switch
corresponds to the track with the same number (e.g., Switch 1 record-arms or -disarms
Track 1, Switch 2 record-arms or -disarms Track 2, etc.).
• Control Bank C: Press the switches to mute or unmute the tracks. Each switch
corresponds to the track with the same number (e.g., Switch 1 mutes or unmutes Track
1, Switch 2 mutes or unmutes Track 2, etc.).
Press Ctrl Bank to cycle through the control banks.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
