USB/SD INPUT
1. Switch on the unit;
2. Insert a USB memory or an Micro SD card into the USB or SD slot (13 or 14). Playback
starts automatically;
3. To pause playback, press (08) button on the unit or the key (08) on remote
control, the display will show "PAUS";press it again to resume playback;
4. Press NEXT or key (06) on remote control while listening to switch (10) button on unit
to the next track. Press PREV or (07) on remote to go to the previous (03)button on unit
tracks;
5. Using the numeric keypad (12) on control you can directly enter the number of remote
the song you want to play;
6. Press once button (09) on the remote, the display will show "ONE", to continually play
the same track; press it a second time, the display will show "ALL" to continuously play all
songs in the USB/SD.
Note:
- The player may not support some USB/SD devices, this is due to the incompatibility of
some processors.
- To avoid harmful interference, always connect USB devices directly to the unit, do not
use extension cords.
- From the computer to format the USB memory/SD FAT (16 or 32).
AUX-IN
1. Press the MODE button (02) on the unit or press button (04) on the remote control
and select the "LINE" function;
2. Connect any unit equipped with audio output, through a cable 3.5mm jack to the
AUX (16) input;
3. Use the external device from their commands.
FM RADIO FUNCTION
1.Turn on the unit and press repeatedly the MODE key on unit, or the on
remote control and select FM function
(the display will show the frequency).
2. Press the PLAY button on the unit or the key o n remote control to activate
the auto memory (the radio starts an automatic search for available radio stations
and saves them automatically). The station's number stored depends on the radio
signal in your area. During the search, press PLAY button on the remote control to
stop searching.
3. Use the NEXT and PREV, or the keys and on the remote control to listen to
the various radio stations saved in memory.
4.To change to a preset station, use the number keys on the remote control.
For example, to call up the station number12 first press 1 and then 2.
USING THE WIRELESS MICROPHONE
1. Remove the cover at the back of the microphone, insert t 2 "AA" size batteries paying
attention to the polarity indicated and close the cover;
2. Turn on the microphone by switch upward.
3. Adjust the volume by pressing the MENU button (07) and Turn the main volume
knob (09) to adjust the volume.
4. If the power indicator flashes when the microphone is turned on, the batteries are low,
replace them immediately.
Note:
- The effective range of the wireless microphone is 15m. Do not use over that range.
- Do not use two microphones working on the same frequency or crosstalk and interference
will occur.
- If you use more wireless microphones at the same time, they must be set to different
frequencies and should be kept away at least at 30m.
- Don’t put the device too close to a DVD/CD/VCD player as they have strong frequencies
and might affect the microphone.
To Next Page
Loading...
