EasyManua.ls Logo

Akai PD-X2210I

Akai PD-X2210I
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
If the display shows the symbol “ ”, this means your batteries are weak, re-
place them or use the AC adaptor.
If the display is blank - no numbers show when power is turned on, the batteries
are dead.
Replace them or use the AC adaptor.
CHARGING AND USE OF RECHARGEABLE BATTERIES
This unit can fully recharge the specified rechargeable batteries, in approximately 15
hours. The rechargeable batteries (NOT supplied) should be recharged before they
are used for the first time or they have not been used for a long period of time be-
cause they are low in power (over 60 days).
1. Open the battery compartment cover and insert two of the recommended recharge-
able batteries, matching polarity. (1.2V 650mA).
ALL BATTERIES MUST BE OF RECHARGEABLE NICKEL-CADMIUM TYPE,
OTHERWISE THE BATTERIES MAY EXPLODE OR LEAK.
2. Plug in the AC ADAPTOR.
3. Slide the recharge switch to “ON” position.
USE ONLY THE AC ADAPTOR FOR CHARGING.
4. After 15 hours, please unplug the AC ADAPTOR and slide the recharge switch to
“OFF” position.
DO NOT CHARGE CONTINUOUSLY FOR 24 HOURS OR MORE. DOING SO
CAN CAUSE THE PERFORMANCE OF THE RECHARGEABLE BATTERIES TO
DETERIORATE.
NOTE: You may play DISC’S whilst charging the batteries.
If the operating time decreases drastically even when the rechargeable nickel-cad-
mium batteries are properly recharged, purchase a new set of rechargeable nickel-
cadmium batteries. When charging for the first time or after a long time, playing time
may be reduced. In this case, charge and discharge the batteries several times.
AUTO POWER ON FUNCTION
The power turns on automatically when the PLAY/PAUSE button is pressed.
AUTO POWER OFF FUNCTION
The power turns off immediately after the disc compartment is opened.
When all the tracks on a disc have been played, or the Stop button is pressed, the
power turns off automatically within 30 seconds if no button is pressed.
If you pressed the Stop button twice the power will turn off
THE HOLD FUNCTION
It is useful during playing, the function will lock the key on the panel to protect the
mistake in the Playing.
During playing slide the HOLD switch to “ON” position, the “HOLD” will appears in
the display, the key on the panel will be locked, the panel key is disable.
Slide the HOLD Switch to “OFF” position to stop the function.
LISTENING WITH HEADPHONE (EARPHONE)
Connect the plug of the stereo headphone (earphone) into the headphone jack
(marked phones) before use the unit.
CAUTION: Hearing experts advise against exposure to continuous extended play at
loud volume levels while using headphone (earphone), possible hearing loss may
result. If you experience a ringing in the ears, reduce volume or discontinue use. We
want you listening for a life time.

Related product manuals