Akai PR006A-471U

Tuning
Manual tuning
Press TUNING + or TUNING – briefly, once or more until the right frequency is found.
Automatic tuning
1. Press and hold down TUNING + or TUNING – until the display frequency starts to run.
2. When a station of sufficient strength has been found tuning stops, or you can stop automatic tuning
by pressing TUNING + or TUNING – again.
Presets
You can store the frequencies of up to 50 radio stations in the memory. A stored frequency can be
erased from the memory by storing another frequency in its place.
Automatic Preset
1. Press and hold down PROGRAM until the display frequency starts to run.
Manual Preset
1. Select your wave band and tune to your desired station (See TUNING).
2. Press PROGRAM once to enter programming mode.
3. Press PRESET + or PRESET – to select the desired memory location.
4. Press PROGRAM once again to confirm the selected station.
5. To listen to a preset station:
• select your waveband;
• press the PRESET + or PRESET – for selecting your desired station.
To improve reception:
- For FM, pull out the telescopic aerial. To improve FM Reception incline and turn the aerial, reduce
its length if the FM-signal is too strong (very close to a transmitter).
Volume
Adjust the sound with the controls VOLUME + or VOLUME -
USB, MICRO SD CARD PLAYBACK
Able to decode and playback all MP3 files which stored in the memory media with USB connector,
MICRO SD Card Slot.
1. Select FUNCTION to MP3.
2. Before connecting the USB media to the unit, make sure the port is in correct direction and will
connect. Or insert MICRO SD Card straightly without bending.
3. The system will automatically start reading the MP3 files in the USB Storage Media, MICRO SD
Card.
4. Press USB MICRO SD PREVIOUS/PLAY/NEXT Buttons for Previous / Play / Next
FUNCTION.
Wrongly connect the USB Storage Media or MICRO SD Card upside down could damage the
unit or the USB Storage Media or MICRO SD Card. A locked MICRO SD Card cannot
detected or playback.
- EN 3 -