produced by: glitchscience.com 2011©
2014©
Fig. 8 - Unscrew the LCD inverter
Remove the Original LCD:
The original LCD backlight has an inverter it is connected to. The inverter is
located behind the LCD and is held in place by 2 screws.
Remove the 2 screws holding the inverter in place.
If you want to remove the LCD without cutting the wiring, remove the two
screws shown in the red rectangle in the photo above. Then push the LCD
through the hole as shown in the photos on the next two pages in Figures 9
through 11. Figure 12 shows the original LCD and inverter board
completely removed, no wires needed to be cut.
To Next Page
Loading...
