Unscrew the black cap on
the underside.
Fill with water and screw
the cap back on.
3.Lay the pedestal (12) with the white side facing downwards, so that you are looking at the dark heavy plate.
Cover the metal rod of the 4 castors (13) with the 4 black plastic sleeves and insert them in the four holes
under the base.
4.Remove the floor bracket (14) from the thread on the underside of the housing (11). Place the fan with the
two pins and the thread on the white upper side of the pedestal (12) and insert it into the openings. Now
secure the housing to the pedestal by tightening the floor bracket on the under- neath metal bracket onto the
white thread and fix the pedestal in place.
5.Now correctly position the fan and you can start to assemble the fan head. First, place the rear fan guard (7)
with the hole on the head’s drive shaft and secure it using the round guard bracket (6).
6.Then take the blade (5) and place it on the drive shaft. Now fix the fan propeller using the blade bracket (4).
7.Then prepare the guard bracket (1) by loosely screwing it together using the connecting screw and a
screwdriver to form a circle. (Only turn it 2-3 times)
8.Now place the front fan guard (3) exactly on the edge of the rear fan guard(7) and place the guard bracket
around the edge of both fan guards. When it has surrounded the fan guards, tighten the guard bracket screw
using a screwdriver.
9.Now insert the misting hose (9) on the mist attachment (2) of the front fan guard.
ATTENTION!
•Do not operate the fan until the safe grills and blade properly installed.
OPERATION ON THE FAN
When connected to the power supply, the indicator will illuminate. The fan is under standby mode. You can
control the fan with the sense touch control panel or the remote control.
The mist fan has many functions that can either be controlled directly on the fan or via the remote control. To
use the remote control, first, insert two AAA 1.5V batteries in the remote control. Fill the fan’s water tank so
that the ultra- sound mist function can be used, then plug the fan into the mains power.
ATTENTION!
• Ensure the product is unplugged from the mains before filling or refilling the water tank.
• Only use water in the water tank. Do not add any chemicals, oils, or other additives.
• Only use cold or warm water in the water tank. The water must not be warmer than 40°C.
To Next Page
Loading...