Akai VS-X9EGN

It. CONTROLS
2019 1817 16 #15
1. Load the video cassette tape here.
2. Multisystem selectors and indicators.
To select the broadcast system.
3. Multisystem AUTO selector.
To set the VCR for automatic system selection.
4. TIMER indicator.
5.
Tape
Speed
indicator
(For
NTSC
system
only).
6. STAND-BY indicator.
Tells you the power cord is plugged in and the
power switch is on.
7.
To
receive
the
remote
control
signal
from
the
Akai
Remote
Control
Unit.
*
Keep
this
window
clean
for
remote
control
Operation.
8. CHANNEL display.
9. CHANNEL selector.
To select a preset channel with the built-in tuner
of the VCR.
10. Tape transport buttons.
To run the tape for recording or playback.
1413 12 11 10 9
11.
12.
13.
14,
15.
16.
17.
18.
19.
20.
Fig. 2-1
EJECT button.
To eject the video cassette tape.
POWER button.
To turn on and off the Akai VCR.
TIMER button.
To stand by for automatic recording.
Tape Speed Selector.
(For NTSC system only.)
Tuning controls.
To tune in preset channels.
Tuning control cover panel.
RF MODE selector.
To select B/G or D/K RF Output.
STILL TRACKING control
To fine tune the STILL playback picture.
TRACKING control.
To fine tune the play back picture.
SHARP/SOFT PICTURE control.
To soften or sharpen the video picture.
vee
SERVICE
MANUAL
——___$—$$—$_—_$—$—_———————
4