Akai X-2000SD - Page 36

Automatic stop lever moves
normally.
Automatic stopping device
Broken plate-shaped spring ‘Check spring.
Broken eccentric gear. Check tri
(Black bakelite gear) PO PECOREIE Bear:
Nail on eccentric gear Check nail on tric gear
broken off. cK nai on eccen gi .
Check if eccentric gear sticking
Holding plate for eccentric :
to holding plate.
gear defective.
Check guide groove on deck
sub-plate and mounting screws.
Defective instant stop =o Check instant stop mechanism.
-Check mounting screw.
Bent REC-PLAY switch
Check lever.
re-setting lever.
Automatic stop lever does not move
Broken lever spring or lever Check lever spring.
or sticky.
spring not in position.
Automatic stop lever sticks _ Check rear side of deck sub-plate.
to rear deck panel.
No lubricant on lever shaft, ___. cjean and re-lubricate lever shaft.
or dust on shaft.
No lubricant on cycle
conversion lever.
Cycle change switch does
Relubricate lever.
not move.
Eccentric or bent cycle
Check cycle conversion lever.
conversion lever.
Capstan drive belt not on
driving track of flywheel.
Check capstan drive belt
Loose motor bushing. Tighten mounting screw.
Loose motor mount screw. Tighten mounting screw.
Wipe off oil with cotton
does not function.
a: on motor bushing o or on flywheel. ——
Cartridge Auto-stop
does not operate |
Cartridge Program Selector
does not operate [
B+ voltage supply to Relay
No B+ voltage supply
Using program selector button 4q
Using the Sensing tape (foil tape)
a
—
‘Cassette Auto-Stop
‘does not operate
38
Cartridge Auto-Stop
operates normally
‘Cartridge Auto-Stop
does not operate
-Program Changing Switch
swab soaked in alcohol.
Relay TR-301 (2SC 1060)
defective
Replace
D-507 (10D-1) defective ‘Replace
C-505 (1000u 6V) defective -—~ Replace
TR-301 (2SC1060) defective —- Replace
‘SW-501
defective
———
Replace
PL-301
defective
Replace
Sensing tape itself defective —— Replace
Loosing contact pine Adjust
TR-501 (2SC536) defective —— Replace
SW-504 defective Replace
CDS defective Replace
Bulb defective Replace
Relay (RL-501) defective Replace
D-507 (10 D1) defective Replace
SW-505 defective Replace