①Tap on“+”to add new camera in the main menu and choose“Smart wireless mode” :
② When the camera’s red light is blinking with the sound“Di-Di”, tap on “Next”to
configure Wi-Fi.
Please make sure your cellphone has connected to a WiFi network.
Please make sure the camera is connecting the same WiFi network as your cellphone.
Please note 5G network is NOT supported.
Choose adding mode
Smart wireless mode (recommended)
Add camera via wifi and soundwave
Wire mode
The camera is connected to the router via a network cable
Add camera
Make sure the camcorder is on and
whether is is available in the wireless
network
Press the RESET hole of the camcorder (1
to 3 seconds)
When you see the blinking red light on the
bulb, tap to continue
Next
Enter Wi-Wi password
Next
Sign up
America internet by connecting to
WLAN router or AP.(5G is not
supported)
WiFi: NETGEAR
③ Choose the correct country (auto positioned by the system) , or change the country
manually and re-login to switch the location information
Next
Sign up
France
Please turn up the volume, and get
close to the camera.
Please choose your current location.
Next
Sign up
France
Please turn up the volume, and get
close to the camera.
Please choose your current location.
Hint
Please make sure the country you
choose matches your current
location which is relative to the
video feed speed.
Cancel Re-login
④ Please turn up the volume of your mobile phone, and get close to the camera (The
sound wave of your phone will help to pair with the camera) . When you hear
“Dingdong”tone from the camera and the indicating light turns to green, tap on
“NEXT” (“NEXT”will only show up after 30 seconds from last operation) .
5 6
To Next Page
Loading...
Need help?
General
