SP2/SP4/SP8/SP8-X20 Manual
Updated until firmware 476 - 25 -
After clicking the “Network” tab you will be taken to this page :-
Once on this page you can setup the network settings as indicated below :-
IP Address :- Use this to change the IP address of your unit
Subnet Mask :- Use this to assign the subnet mask of your unit
Default Gateway :- Assign the default gateway of your device
Domain Name Server :- IP address of your DNS. Used if you wish to use a DNS address for
your unit instead of accessing via the IP address.
Use DHCP :- The unit can use DHCP to assign its IP address, or it can use a statically assigned
IP address. To use DHCP choose “Use DHCP” from the list box and press set. To stop using
DHCP choose “Do Not Use DHCP” from the list box and press set. Statically assigning an IP
address also turns off DHCP. You can force the SP2 / SP4 / SP8 to voluntarily give up its IP
lease and request a new IP lease by choosing Use DHCP from the list box and pressing “set”.
To Next Page
Loading...
Need help?
General
