SP2/SP4/SP8/SP8-X20 Manual
Updated until firmware 476 - 24 -
At the bottom of the page you have two further options.
Status of most recent Mail :- This can be either “No Status” “Success” or “Failure”
Last Error Message :- This is a debugging aid. If the email is not successfully sent, you may find
the reason for the problem here.
Test Email :- Useful when you first set up the SMTP settings to ensure they are working, or
anytime thereafter. Before a test mail can be generated ensure the previous fields described have
been completed.
Important Note:
If you are still having problems connecting to your SMTP email server, then please check the
additional trouble shooting tips in the FAQ section #7 at the end of this manual.
5) System settings
Network settings
The networks settings page allows you to change network settings for your unit such as the IP
address etc.
Important Note:
You can change your default HTTP port on the unit is using via this SNMP set command:
snmpset -m all -v1 -c <community> <ipaddress> .1.3.6.1.4.1.3854.1.2.2.1.91.0 u <port>
You can still use port 80 for web access as well.
(continued on next page)
To get to the entry point of this tutorial complete the following :-
1) Point your web browser to the IP address of your unit
2) Log in as administrator
3) From the settings page, select the network tab.
To Next Page
Loading...
Need help?
General
