SP2/SP4/SP8/SP8-X20 Manual
Updated until firmware 476 - 23 -
Send Mail :- This toggles whether the send Email option is on or off.
SMTP Server :- The address of your SMTP server
SMTP Authentication :- check this option if your SMTP server requires authentication
SMTP Server Login Name :- The user name to login to your SMTP server
SMTP Server Password :- The password used to login to your SMPT server
E-mail subject :- The subject you wish to have for the e-mail. Eg. “sensorProbe notification”
Timeout :- You can increase the timeout for SMTP servers that have poor connectivity. It is best
to leave this number as low as possible while still allowing for communication with the SMTP
server to continue.
Resend Intervals :- The time between which the e-mails will be sent
Maximum Times To Resend :- Set the number of times you wish for the notification e-mails to
be resent.
Send Keep Alive Email :- This option will tell the unit to send a heartbeat e-mail. This is useful to
tell if the unit is still online or not. It is also used when you require collection of data at regular
intervals.
Keep Alive Email Resend Interval :- The amount of time between which the keep alive emails
are sent.
After setting your parameters click the save button.
Below this you will see there is anther section. This is for configuring who the e-mails are to be
sent too.
Mail From :- The email address which you would like the e-mail to appear from. Due to anti-spam
features of some SMTP servers this address must be authorized on the SMTP server otherwise
the server may deny the email.
Mail Recipient :- The email address of the person you wish for the email to be sent to.
Mail Cc1-5 :- Up to five additional e-mail addresses may be added.
When you have filled in your required fields remember to click “Save”.
To Next Page
Loading...
Need help?
General
