SPX+ Introduction Manual - updated until firmware 4997
- 4 -
Introduction
In this manual, we’ll cover the main features and basic configuration of the SPX+ and the setup of
notifications and the explanation of events will be in another manual.
What is the SPX+?
sensorProbeX+ is the latest generation of sensorProbe devices. In a completely new form factor that
allows for 1U, 0U and DIN rail mounting with a low profile design it takes up much less cabinet space.
SPX+ comes in several standard configurations, but with the AKCP configuration tool you are able to
custom design a unit to your own specifications. Choose from various modules to specify the number
of dry contacts, sensor ports or an internal modem.
Please check our SPX+ unit configurator tool on our website, where you can build your own custom
configuration:
http://www.akcp.com/configuratorTool/
You can also view our SPX+ video on our YouTube channel:
https://youtu.be/8ACjfn7PswA
SPX+ Features:
● Modular design, 1U, 0U and DIN rail mounting
● IP based, including SNMPv3, HTTPS, VPN
● Send encrypted SNMP Trap and Email Notifications
● Supports at least 4 Intelligent Sensors, expansion units and up to 120 Dry Contacts
● Optional cellular modem with external antenna
● Notification Wizards
● Front and Rear Thermal Mapping for any server cabinet
● Low Cost Daisy Chained Temperature sensors
● Optional Expansion Module connectivity
● Virtual Sensors
● Patented Fire Suppression feature
● AKCP Swing Handle Lock support
● Optional Dry Contact Sensors in I/O and Opto-Isolated modes
Important notes:
A) Some of the pictures shown in this manual might not represent the actual Web UI of the unit and
may refer to the SP2+ unit; this is because the SPX+ is a new family of units and its Web UI is
basically all the same as SP2+. We are constantly working on improving the firmware; please provide
us with feedback if you have any issues configuring your unit.
To Next Page
Loading...
Need help?
General
