Need help?Do you have a question about the AKG D 65 S and is the answer not in the manual?
General| Type | Dynamic |
|---|---|
| Impedance | 600 Ohms |
| Sensitivity | 2.5 mV/Pa |
| Polar Pattern | Cardioid |
| Connector | XLR |
Details the microphone's acoustic tuning for voice and recording, neutral sound, and intelligibility.
Highlights robust construction, hypercardioid pattern, integrated wind/pop screen, and ON/OFF switch.
Explains low impedance, balanced outputs and connection to symmetrical or asymmetrical inputs.
Describes the microphone's operating principle as a dynamic pressure gradient receiver.
Specifies the microphone's directional characteristic as hypercardioid.
Details the frequency range from 80 Hz to 20,000 Hz.
Provides sensitivity at 1 kHz as 2.0 mV/Pa.
States the impedance at 1 kHz as 500 Ω and recommended load impedance as 1200 Ω.
Specifies maximum sound pressure level for 1%/3% THD.
Identifies the connector as a 3-pin XLR.
Details pin assignments for ground, inphase audio, and audio.
Provides the microphone dimensions in mm and inches.
Mentions the included accessory: SA 44 stand adapter.
Identifies the product as a dynamic pressure gradient microphone.
Specifies the polar pattern as hypercardioid.
States the frequency range is 80 Hz to 20,000 Hz.
Provides sensitivity at 1000 Hz as 2.0 mV/Pa.
States impedance at 1000 Hz is 500 Ω.
Specifies the recommended load impedance as 1200 Ω.
Details maximum SPL for 1% and 3% THD.
Identifies the connector type as 3-pin male XLR.
Details pin assignments: pin 1 ground, pin 2 audio (inphase), pin 3 audio.
States the case material is die-cast.
Specifies the finish as matte black.
Provides dimensions: 50 (dia.) x 176 mm (2.1 x 7.3 in.).
Lists net/shipping weight: 233/420 g (7.4/17.7 oz.).
Lists the standard accessory: SA 44 stand adapter.
To Next Page
