6 Error Messages
36
PT 4500
• The above error messages may appear on the display upon powering up or during operation:
• To delete an error message, push the setup switch.
• For more hints on troubleshooting, refer to the SR 4000 receiver manual.
Error Message Problem Remedy
Err.>JoG< Internal setup switch error. 1. (Setup switch responds in spite of
error message:) Switch power to
transmitter off, wait for 10 sec-
onds, and switch power back on.
2. (Setup switch fails to respond:) Re-
move and reinsert batteries/BP
4000 battery pack, and switch
power to transmitter on.
3. If error persists, contact your near-
est AKG Service Center.
To Next Page
