AKONA DRIFTER - Page 7

To Next Page

To Previous Page

OWNER’S MANUAL

Inate oor next to 1.0 PSI. Unscrew the top of the Boston valve, inset pump hose and

inate the oor. DO NOT OVER INFLATE. When complete, screw top of Boston valve

back on.

Look over the KAYAK to make sure it appears straight. The bladders can occasionally

twist in casing so the bladders may need to be deated slightly to correct how the

bladders are positioned. Access points on the kayak are available so if needed, you

can adjust bladders. If repositioning of bladders was needed and complete, inate

the side tubes rst then the oor.

NOTE:

ASSEMBLY INSTRUCTIONS

Place seat(s) in kayak cockpit. The seat will connect to the oor with Velcro and

tensioning straps with clips for adjustability. Position the seat(s) so that the weight

of the paddler(s) will balance the kayak. If assembling a double, the heavier paddler

should be in the back of kayak.