en
12 1 651 934_c
ADVICE
Replacement parts are safety parts!
For the installation of replacement parts
into our products, we recommend the
use of original AL-KO parts, or of parts
that we have expressly approved for in-
stallation. For the clear identification of
replacement parts, our service stations
require the replacement part identifica-
tion number (ETI).
Type plate
1 ETI number
2 Drawing number
TROUBLESHOOTING
Malfunction Possible cause Solution
Excessive abrasion losses
on the overrun hitch
Corrosion on the pull rod
Remove dirt and corrosion from the
transmission device and brake cable,
and then check for ease of movement.
Pull rod slides in completely Check the brake adjustment
Inadequate braking effect
Serious damage when ma-
noeuvring
Contact an AL-KO service centre
Reversing is difficult or blo-
cked
Brake system set too tightly Have the brake system adjusted
Driving is not smooth, or
braking is jerky
Shock absorber is defective Have the shock absorber renewed
Inadequate handbrake effect Brake system set too tightly Have the brake system adjusted
Height adjustment of over-
run hitch is stiff
Drawbar joints have sei-
zed
Adjusting aid has seized
Loosen, clean, and lubricate the joints
Little or no weight balancing Gas spring too weak or de-
fective
Have the gas spring replaced
ADVICE
If you encounter any malfunctions that are not listed in this table or which you cannot rectify
yourself, please contact our appropriate customer service.
To Next Page
Loading...
Need help?
General
