Why is the braking action too weak on my AL-KO 252 VB-2 Lawn Mower?
If the braking action of your AL-KO Lawn Mower is too weak, it could be due to high frictional losses in the transmission system, corrosion at the drawbar, or the drawbar sliding in completely. To resolve this, make the transmission system and brake cable smooth-running and grease them. If the issue is due to impact damage during maneuvering, visit an AL-KO service station.
What to do if my AL-KO Lawn Mower has unstable road behavior and jerky braking?
If your AL-KO Lawn Mower exhibits unstable road behavior or jerky braking when releasing the throttle, the shock absorber of the IBS might be defective. In this case, have the shock absorber(s) replaced.
Why is reversing stiff or blocked on my AL-KO Lawn Mower?
If reversing is stiff or blocked on your AL-KO Lawn Mower, it may be because the brake system is set too tight. To fix this, have the brake system adjusted.
What to do if my AL-KO 252 VB-2 has little or no weight compensation?
If your AL-KO Lawn Mower has little or no weight compensation, the gas spring might be too weak or defective. Have the gas spring replaced to resolve this issue.
Why is the handbraking action too weak on my AL-KO 252 VB-2?
If the handbraking action of your AL-KO Lawn Mower is too weak, it could be due to a defective gas spring. To solve this, have the gas spring replaced.
How to fix a stiff IBS height adjustment on my AL-KO 252 VB-2?
If the IBS height adjustment on your AL-KO Lawn Mower is stiff, it may be due to blocked joints of the steering rod or a blocked adjustment support. To resolve this, loosen, clean, and grease the joints.
Why is the IBS height adjustment unstable on my AL-KO 252 VB-2 Lawn Mower?
If the IBS height adjustment on your AL-KO Lawn Mower is unstable, it could be because the joints of the steering rod are loose. Clean and grease the joints to fix this.
Explains symbols used in the manual for better understanding and handling.
Instructions for attaching and using the breakaway cable correctly.
Procedure for parking the trailer and associated safety warnings.
Requirements for vehicle installation and breakaway cable routing.
Step-by-step guide to adjusting the inertia braking system.
Correct procedures for applying and releasing the handbrake.
Detailed steps for looping the breakaway cable around the ball plate.
Alternative methods for breakaway cable attachment.
Specific instructions for breakaway cable attachment in the Netherlands.
Tasks to be performed at 6-month and 10000-15000 km intervals.
Measures to reduce white rust on hot-dip galvanized surfaces.
Warning that repairs must only be carried out by trained personnel.
Emphasis on using original AL-KO parts for safety and identification.
General| Engine Type | Petrol |
|---|---|
| Cutting Width | 51 cm |
| Cutting Height | 30 - 80 mm |
| Cutting Height Range | 30 - 80 mm |
| Cutting Height Adjustment | Central |
To Next Page
