Why is the braking action too weak on my AL-KO 161 VB-2?
If the braking action of your AL-KO Lawn Mower is too weak, it could be due to high frictional losses in the transmission system, corrosion at the drawbar, or the drawbar sliding in completely. To resolve this, make the transmission system and brake cable smooth-running and grease them. If the issue is due to impact damage during maneuvering, visit an AL-KO service station.
What to do if my AL-KO 161 VB-2 Lawn Mower has unstable road behavior and jerky braking?
If your AL-KO Lawn Mower exhibits unstable road behavior or jerky braking when releasing the throttle, the shock absorber of the IBS might be defective. In this case, have the shock absorber(s) replaced.
Why is reversing stiff or blocked on my AL-KO 161 VB-2 Lawn Mower?
If reversing is stiff or blocked on your AL-KO Lawn Mower, it may be because the brake system is set too tight. To fix this, have the brake system adjusted.
What to do if my AL-KO Lawn Mower has little or no weight compensation?
If your AL-KO Lawn Mower has little or no weight compensation, the gas spring might be too weak or defective. Have the gas spring replaced to resolve this issue.
Why is the handbraking action too weak on my AL-KO 161 VB-2?
If the handbraking action of your AL-KO Lawn Mower is too weak, it could be due to a defective gas spring. To solve this, have the gas spring replaced.
How to fix a stiff IBS height adjustment on my AL-KO Lawn Mower?
If the IBS height adjustment on your AL-KO Lawn Mower is stiff, it may be due to blocked joints of the steering rod or a blocked adjustment support. To resolve this, loosen, clean, and grease the joints.
Why is the IBS height adjustment unstable on my AL-KO Lawn Mower?
If the IBS height adjustment on your AL-KO Lawn Mower is unstable, it could be because the joints of the steering rod are loose. Clean and grease the joints to fix this.
Instructions on how to attach the breakaway cable correctly and safely.
Step-by-step guide for adjusting the inertia braking system.
Important safety precautions to follow before maintenance or inspection work.
Table listing faults, their causes, and suggested remedies for the overrun device.
General| Cutting Height Range | 25-75 mm |
|---|---|
| Cutting Height | 25-75 mm |
| Weight | 28 kg |
| Engine Type | 4-stroke |
| Cutting Height Adjustment | Central |
To Next Page