AL-KO HT 440 Basic Cut - General Power Tool Safety Warnings; Technical Data

Translation of original user instructions
14
AL-KO Hedge trimmer
Technical data
Technical data HT 440 Basic Cut HT 550 Safety Cut
Power consumption 440 W 550 W
Cutter length 440 mm 520 mm
Cutting thickness 16 mm 18 mm
Total weight 3,2 kg 3,6 kg
Vibrations measured at handle* 2,2 m/s² (K = 1,5 m/s²) 2,9 m/s² (K = 1,5 m/s²)
Mains voltage 230V-240V / 50Hz 230V-240V / 50Hz
Insulation class
/ II / II
No-load stroke rate 1600 m
-1
1600 m
-1
Sound pressure level L
PA
86 dB (A) (K = 1,5 dB (A)) 86 dB(A) (K = 1,5 dB (A))
* The declared vibration total value has been measured in accordance with a standard test method and
may be used for comparing one tool with another. The declared vibration total value may also be used in a
preliminary assessment of exposure.
General Power Tool Safety Warnings
Caution!
Read all safety warnings and all instruc-
tions.
Failure to follow the warnings and instructions
may result in electric shock, re and/or serious
injury. Save all warnings and instructions for
future reference.
Caution!
Use the equipment only if it is in correct
operating condition! Before using, check the
machine, cable and plug for damage; any
damaged parts must be repaired or replaced at
a specialised repair centre.
Caution - Danger of electrocution!
If the cable has been cut or is damaged,
disconnect the plug from the mains supply
immediately.
Caution - Risk of injury!
Safety/protection devices should not be
disabled!
Warning!
The vibration emission during actual use of the
power tool can differ from the declared total
value depending on the ways in which the tool
is used.
Caution!
Only hold the electrical equipment on the insu-
lated grip areas as the cutting blade may come
into contact with concealed power lines or with
the mains cable itself.
The cutting blade coming into contact with a live
cable may make parts of the equipment live and
result in an electric shock.