What to do if the AL-KO Automobile Accessories remote control does not perform an LED test when switched on?
If the AL-KO Automobile Accessories remote control doesn't perform an LED test, the batteries might be depleted. Try exchanging the batteries in the remote control. If that doesn't work, the remote control may be defective, in which case you should exchange it and calibrate the new one.
What to do if AL-KO Automobile Accessories initial start-up procedure cannot be carried out?
If the initial start-up procedure for your AL-KO Automobile Accessories cannot be carried out, check the drive supply battery. It may be depleted, defective, or not connected. Charge, exchange, or connect the battery as needed. Also, check the fuse; it may be removed or defective. Ensure that one of the 3-contact connectors is unplugged, and check the battery and remote control, exchanging if necessary.
Why AL-KO Automobile Accessories LED “Remote control battery status” flashes?
If the “Remote control battery status” LED on your AL-KO Automobile Accessories is flashing, it means the batteries are nearly depleted. Complete the manoeuvring operation and then change the batteries.
Why AL-KO Automobile Accessories LED “Drive supply battery status” flashes?
If the “Drive supply battery status” LED is flashing on your AL-KO Automobile Accessories, it indicates that the battery is nearly depleted. You should complete the maneuvering operation and then charge the battery.
What to do if AL-KO Automobile Accessories system establishes radio contact, but the drives cannot be moved onto the wheels?
If the AL-KO Automobile Accessories system establishes radio contact but the drives can't be moved onto the wheels, check the connections of the supply cable. Ensure all connectors, including the 3-contact connectors, are plugged in.
What to do if AL-KO Automobile Accessories function execution interrupted unexpectedly during engagement, manoeuvring or disengagement?
If the function execution is interrupted unexpectedly during engagement, maneuvering, or disengagement of your AL-KO Automobile Accessories, the radio connection may be poor or interrupted. Try reducing the distance to the drives and observe a minimum clearance of 0.5 m.
Why AL-KO Automobile Accessories system does not establish radio contact?
If the AL-KO Automobile Accessories system does not establish radio contact, and the operating state LED on the remote control does not remain green after attempting engagement, it may be because no initial start-up was carried out. Repeat the initial start-up procedure.
General| Type | Robotic lawn mower |
|---|---|
| Suitable for lawn areas up to | 1000 m² |
| Cutting width | 22 cm |
| App control | Yes |
| Rain sensor | Yes |
| Grass Collection | Mulching |
| Charging time | 60 min |
To Next Page
