Stream Video Recorder - (ADC-SVR122) Installation Guide
Pre-Installation Checklist
• SVR (included)
• AC power adapter (included)
• Ethernet connection to broadband (Cable, DSL or Fiber Optic) Internet
• Login and Password for the Alarm.com account to which you will add the SVR
Add the Device to an Alarm.com Account
1. Using an Ethernet cable, connect the device to the network.
2. Connect the device’s AC power adapter and plug it into a non-switched outlet. Wait for the SVR Status LED (on
front) to turn solid green.
3. Add the device to the account by either selecting the account in MobileTech OR by using a web browser and
entering the following URL: www.alarm.com/addcamera
4. Select the device from the video device list or type in its MAC address to begin adding the camera. The device’s
MAC address is located on the bottom of the device.
5. Follow the on-screen instructions to finish adding the device. You may associate cameras to the device from the
Customer Website.
https://answers.alarm.com/Installation_and_Troubleshooting/Video_Devices/Stream_Video_Recorder_-_(ADC-SVR122)/Stream_Video_Recorder_-_(ADC-SVR122)_Installation_Guide
Updated: Wed, 02 May 2018 19:46:29 GMT
1
To Next Page
Need help?
General
