LED Color Pattern Description
Flashing Red
SVR firmware versions 1.0.1.2+
SVR is booting
SVR firmware versions
below 1.0.1.2
No connection
Check your Internet service and the
Troubleshooting section
Flashing Green & Red
Factory reset
Caution: This will restore factory-
default settings to the device. If
already installed, the device
may need to be removed from the
Alarm.com account and re-added
after a factory reset.
To perform a factory reset, push the
Reset button and release when
flashing Green and Red
(about 15 seconds).
SVR Hard Drive
LED Color Pattern Description
Solid Green SVR hard drive is operating normally
Flashing Green
Hard drive is full
Normal operation, oldest footage is
being deleted
https://answers.alarm.com/Installation_and_Troubleshooting/Video_Devices/Stream_Video_Recorder_-_(ADC-SVR122)/Stream_Video_Recorder_-_(ADC-SVR122)_Installation_Guide
Updated: Wed, 02 May 2018 19:46:29 GMT
3
To Next Page
Loading...