6 ADC-V722W Installation Guide
Troubleshooting
• If you have issues connecting the camera to the account, power
cycle the camera and try again.
• If issues persist, reset the camera to factory defaults by using the
WPS button located on the back of the camera. Press and hold
the WPS button until the LED is flashing Green and Red (about
15 seconds), then release the button. The camera will reboot with
factory defaults. If the camera was previously installed to an Alarm.
com account, it will need to be deleted before it can be
installed again.
Questions?
Visit: www.alarm.com/supportcenter
To Next Page
Loading...
Need help?
General
