3
Installation
Service provider technician - MobileTech installation
❶ Log in to MobileTech.
❷ Select the customer’s account.
❸ Tap Quick Actions > Add Device > Video.
❹ Follow the on-screen instructions.
Ethernet mode
Complete these steps prior to installing the camera in its final location:
❶ Connect the camera to the router via an Ethernet cable.
❷ If the Ethernet connection does not provide power, connect the camera to the optional
AC power adapter (sold separately) and plug the adapter into a non-switched outlet.
❸ Wait 2 minutes for the camera to boot up and connect to the Internet. The LED will be
solid green when this process is complete.
❹ Add the device to the account by either selecting the account in MobileTech or by using
a web browser and entering the following URL: www.alarm.com/addcamera (you will
need the customer username and password).
❺ Select the camera from the video device list or enter its MAC address to begin adding
the camera. The camera’s MAC address is located on the bottom of the device or on
the packaging.
❻ Follow the on-screen instructions to finish adding the camera.
You can now power down the camera.
To Next Page
Loading...
Need help?
General
