English
• The rubber ring will act as a seal against DIN Sleeve. At the left and right sides
of the ring a slot space will be provided by pulling slowly the left and right side
of the ring.
• The slots in the fitted rubber ring will enable the proper removal of radio from
the DIN sleeve.
Removing the radio from DIN Sleeve
If you plan to remove the radio from DIN Sleeve, you should do it using the provided
two removal keys as explained below:
• Fully insert both removal keys straight into the slot spaces provided by rubber
ring on the left and the right edges of the radio front panel.
• You cannot remove the radio if only one key is used.
• Press in fully and the radio will unlock from the sleeve making withdrawal from
the sleeve possible.
• Store the keys in a safe place for future use.
To Next Page
Loading...
