ALBRECHT AIRCONTROL M8
LOCATION OF CONTROLS
1 .Antenna
2. Squelch control
3. On/off volume control
4. Tuning control
5. DC adapter jack
6. Earphone socket
7. Speaker
8. Battery case
HOW TO OPERATE YOUR RADIO
DC OPERATION
Remove battery case of the cabinet, and insert 4 penlight 1.5V, batteries into the battery
case. Be sure the battery position is correct by referring to the negative on spring con-
nector. Otherwise, circuit components may be damaged.
NOTE: WEAK OR DEAD BATTERIES MAY LEAK AND CORRODE THE SET:
ALWAYS REMOVE BATTERIES WHEN THE SET WILL NOT BE USED FOR A
LONG PERIOD OF TIME.
POWER ON/OFF SWITCH
Put the power ON/OFF Switch to ON position.
TELESCOPIC ANTENNA
Extend the telescopic antenna to its full length that gives the clearest sound. When liste-
ning to nearby or strong stations, it is often desirable to shorten the antenna to avoid dis-
torted sound.
TUNING
Your radio can be slide on to CB/TV1-FM/AIR-PB-WB bands by the Band Selector. Just
turn the Tuning Control Knob to your favorite station and adjust Volume Control Knob for
proper volume.
AIR-PB-WB RECEPTION
Extend the telescopic antenna to its full length that gives the clearest sound. Slide Band
Selector to “AIR-PB-WB” position and tune to any desired station, the “AIR-PB-WB” LED
will lit.
1
23
4
5
6
8
7
To Next Page