system should no more be able to
open without interruptions.
• Press
3 x. This disables
the automatic squelch and
lets You hear everything on
the channel with highest
possible sensitivity.
• Press again
1 x to go
back to normal squelch mode.
Channel Scan
Channel SCAN performs automatic
searches for active signals in an
endless loop over all channels from 1
to 8.
• Press
S button for about b1/2
to 1 second to activate SCAN.
The channel number on the LCD
Screen changes rapidly until an active
signal is detected during channel
scan mode.
• If desired, press the PTT
button shortly to stop on the
selected channel or press
MENU
1x to deactivate
channel scan mode again.
• When an active signal on one
of the 8 channels is detected,
scan mode pauses about 3
seconds while You can hear
the radio traffic on the active
channel.
To Next Page
Loading...
