8AL90850USAAed01 17
PROCEDURE: “Adjusting the Antenna position”.
Note: Antenna position can be changed once. You should not change it back!
Actions
1. Remove the two screws from the rear side of the cabinet.
Figure 4. Rear side of Cabinet.
2. Open the cabinet CAREFULLY! Make sure that you shift the cover of the antenna’s
carefully from the antenna’s.
3. Take the antenna cover from the 4080 IP-DECT cover.
4. To put the antennas in vertical position, bend them
carefully Figure 5.
Bend Antennas carefully into vertical position.
as shown in
Screws are inside these holes
To Next Page
Loading...
