Alcatel-Lucent OAW-AP - Pre-Installation Procedures; OAW-AP Connection Specifications

Item Name
Specifications
Security Lock
Slot
The OAW-AP is equipped with a security lock slot for additional security.
Reset Button
Press and hold the reset button for approximately 5 seconds then release. The LED will
turn off and then turn red as the AP reboots to the factory default settings.
Console Port
The console port is an RJ-45 female connector and can be used to connect to a terminal
for direct local management. Note: Currently for use by Service & Support only.
Ethernet Port
The OAW-AP is equipped with one 10/100/1000Base-T (RJ-45) auto-sensing, MDI/MDX
wired-network connectivity port.
DC Power Socket
The OAW-AP has a single 48V DC power jack socket to support powering through an AC-
to-DC power adapter, If PoE is not available, an optional AC-DC adapter kit (sold
separately) can be used to power the OAW-A P.
Table 1: OAW-AP Connections
Pre-installation
FCC Statement: Improper installation of access points in the United States configured to non-US model
controllers will be in violation of the FCC rules. Any such willful or intentional violation may result in a
requirement by the FCC for immediate termination of operation and may be subject to forfeiture (refer
to 47 CFR 1.80).EU Statement: Low power radio LAN product operating in 2.4 GHz and 5 GHz bands. Please
refer to the ALE OS User Guide for details on restrictions.
For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other
channels is not possible. This device is restricted for indoor use.
Pour les produits disponibles aux États-Unis / Canada du marché, seul le canal 1 à 11 peuvent être
exploités. Sélection d'autres canaux n'est pas possible. Pour une utilisation en intérieur uniquement.
Dynamic Frequency Selection (DFS) for devices operating in the bands 5250- 5350 MHz, 5470-5600 MHz and
5650-5725 MHz.
Sélection dynamique de fréquences (DFS) pour les dispositifs fonctionnant dans les bandes 5250-5350 MHz,
5470-5600 MHz et 5650-5725 MHz.
The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for
harmful interference to co-channel mobile satellite systems.
les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une. Utilisation à
l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles
utilisant les mêmes canaux.
Users should also be advised that high-power radars are allocated as primary users (i.e. priority users) of
the bands 5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or
damage to LE-LAN devices.
OAW-AP Installation Guide
ALCATEL-LUCENT ENTERPRISE 4