Index
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 Index-5
LDAP accounting servers
dynamic log 31-24
standard attributes 31-23
LDAP authentication servers
directory entries 31-17
functional privileges 31-22
passwords for 31-20
schema extensions 31-17
SNMP attributes on authentication servers 31-22
SSL 31-26
VSAs for Authenticated Switch Access 31-21
LDAP servers
see policy servers
used for QoS policies 27-3
Learned Port Security
database table 33-8
defaults 33-2
disabling 33-11
enabling 33-11
overview 33-5
Learned Port Security Configuration
Application example 33-3
Lightweight Directory Access Protocol
see LDAP servers
line speed 1-3
link aggregation
dynamic link aggregation 9-1, 10-1
Spanning Tree parameters 6-35, 6-36, 6-38, 6-39, 6-41
static link aggregation 8-1
lldp lldpdu command 13-3
lldp notification command 13-3
lldp tlv dot1 command 13-9
lldp tlv dot3 command 13-9
lldp tlv management command 13-3
lldp tlv med command 13-10, 13-12
logged events
detail level 26-39
types of events 26-38
M
MAC address table 3-1, 3-3
aging time 3-7
duplicate MAC addresses 3-3
learned MAC addresses 3-3
static MAC addresses 3-3
MAC addresses
aging time 3-7, 6-30
dynamic link aggregation 9-14, 9-15, 9-17, 9-22
learned 3-3
statically assigned 3-3
mac-address-table command 3-3
map groups 26-60
application 26-78
creating 26-61
verifying information 26-62
master router
VRRP 23-5
MLD Zapping 25-40
MST 6-12
Internal Spanning Tree (IST) Instance 6-17
Interoperability 6-18
Migration 6-18, 6-19
MSTI 6-15
MSTP 6-12
Multiple Spanning Tree Region 6-16
Multicast Listener Discovery (MLD) 25-29
Multiple Spanning Tree
defaults 6-4
N
non combo ports
configuring 1-3
O
OSPF 19-4
defaults 18-2, 20-2
loading software 20-14
OSPF redistribution policies
deleting 15-22, 15-24, 17-22, 17-24, 19-16
P
pending configuration 26-71
pending policies
deleting 26-71
Per VLAN DHCP 21-8
PIM-SM 25-6
ping
IP 15-34
ping command 15-34
policies
application examples 26-74
applied 26-71
built-in 26-36
conditions 26-44
creating policy actions 26-45
how the switch uses them 26-28
Policy Based Routing 26-79
precedence 26-48
redirect linkagg 26-76
redirect port 26-76
rules 26-46
verify information about 26-52
policies configured via PolicyView 26-72
policy action 802.1p command 26-8
policy action command 26-42
policy action map command 26-60
policy action redirect linkagg command 26-76
policy action redirect port command 26-76, 26-77
policy actions
see actions
Policy Based Routing 26-79
policy condition command 26-42
policy conditions
see conditions
policy MAC groups 26-57
To Next Page
Loading...
