56
Getting started
2
............
Set-up2.1
Removing and installing the back cover
Removing and installing the battery
Inserting and removing the SIM card
Inserting and removing the TF card
Charging the battery
Connect the battery charger to your phone and mains socket
respectively.
The charging may take about 20 minutes to start if the •
battery is flat.
Be careful not to force the plug into the socket. •
Make sure the battery is correctly inserted before •
connecting the charger.
The mains socket must be near to the phone and easily •
accessible (avoid electric extension cables).
When using your telephone for the first time, charge the •
battery fully (approximately 3 hours). You are advised to
fully charge the battery (
).
To reduce power consumption and energy waste, when •
battery is fully charged, disconnect your charger from the
plug; reduce the backlight time, etc.
The charge is complete when the animation stops.
Power on your phone2.2
Hold down the key until the phone powers on.
Power off your phone2.3
Hold down the key from the idle screen.
IP4514_ALCATEL 1060_QG_Eng_GB_14_130325.indd 5-6IP4514_ALCATEL 1060_QG_Eng_GB_14_130325.indd 5-6 2013-3-25 11:30:232013-3-25 11:30:23
To Next Page
Loading...
