To Next PageTo Next Page
Need help?Do you have a question about the Alcofind AF-100S and is the answer not in the manual?
Highlights key features of the AF-100S breathalyzer for police and workplace use.
Essential safety rules including calibration, handling, environmental conditions, and usage restrictions.
Locates and names parts visible on the front of the AF-100S device.
Locates and names parts visible on the back of the AF-100S device.
Step-by-step guide for safely detaching the blow cap from the device.
Initial step for installing the blow cap: aligning it with the blue sensor.
Completing blow cap installation by securing all parts tightly.
Connect the Micro USB cable to charge the battery, observing LED indicators.
Key considerations for charging, including usage restrictions and USB port requirements.
Instructions for powering on the AF-100S using the ON/OFF button.
Interpreting purple LEDs that display the total number of tests performed.
Interpreting red LEDs showing time remaining until next calibration.
Interpreting red and blue LEDs indicating remaining battery percentage.
Explains blue LED displays for battery power from 20% to 100%.
Describes the automatic countdown and indicators when the device is ready for testing.
Guide on blowing a sufficient sample and device response to a valid test.
How the device displays a 'PASS' result for BAC levels below the alarm limit.
Explains 'WARN' and 'FAIL' indications based on BAC percentages relative to the alarm limit.
How to turn off the device and information on its automatic shut-off feature.
Procedure to access alarm level configuration by pressing multiple device buttons.
How to choose between five distinct alarm levels using the LIGHT button.
Steps to save the selected alarm level and return to the countdown.
How to momentarily show the active signal lamp mode during operation.
Guide to selecting one of seven different signal lamp visual patterns.
Details on sensor type, display LEDs, warm-up, responding, and recovery times.
Covers alarm levels, buttons, temperature, power, battery life, dimensions, weight, and calibration.
General| Sensor Type | Semiconductor |
|---|---|
| Device Type | Breathalyzer |
| Power Supply | 2 x 1.5V AAA batteries |
| Warm-up Time | 10 seconds |
| Response Time | 5 seconds |
| Operating Temperature | 10 ~ 40 ℃ |
| Calibration | Every 6 months |
| Display | LCD |
| Auto Power Off | Yes |
