Sensors
To access all settings, tap on the Settings icon in the top right
corner of the Home Screen and enter your 4-digit Master Code.
Only the Master Code can access Settings.
ADD A SENSOR
To add a sensor, go to Settings > Enter your 4-digit Master
Code > Sensors > Select the sensor type >Tap “Add Sensor” at
the bottom of the screen >Trigger the sensor (a beep will sound
indicating the sensor has successfully been added) > select a
name for the new sensor based on its location on the premise >
select to add more of the same sensor or tap Done Adding >
Verify your sensor signals are being received by the Central
Monitoring station by running a Complete Sensor Signal Test
(See ‘Complete Sensor Signal Test’ on page 29).
REMOVE A SENSOR
To remove a sensor, go to Settings > Enter your 4-digit Master
Code > Sensors > Select the sensor type > Tap “X” on the row of
the sensor you want to remove > When asked “Are you sure you
want to remove the sensor?” tap “Yes.”
RENAME A SENSOR
To rename a sensor, go to Settings > Enter your 4-digit Master
Code > Sensors > Select the sensor type > Tap “Edit” on the row
of the sensor you wish to rename > Tap the Edit Name icon to
the right of the Sensor Name > Select a new name > Tap “Done”
or “View Sensor Settings”.
BYPASS A SENSOR
To bypass a sensor (turn it off until you turn it back on) go to
Settings > Enter your 4-digit Master Code > Sensors > Select the
sensor type > Tap “Edit” on the row of the sensor you wish to
Bypass > on the “Bypass” Row tap “ON” > When asked, “Are you
sure you want to temporarily disable this sensor?” tap “Yes”.
TURN CHIME ON/OFF
To turn Chimes on or off, go to Settings > Enter your 4-digit
Master Code > Sensors > Select the sensor type > Tap “Edit” on
To Next Page
Loading...